Move and replace hardware - AFF A300
Step 1: Move a power supply
Moving out a power supply when replacing a chassis involves turning off, disconnecting,
and removing the power supply from the old chassis and installing and connecting it on
the replacement chassis.
1. If you are not already grounded, properly ground yourself.
2. Turn off the power supply and disconnect the power cables:
a. Turn off the power switch on the power supply.
b. Open the power cable retainer, and then unplug the power cable from the power supply.
c. Unplug the power cable from the power source.
3. Press down the release latch on the power supply cam handle, and then lower the cam handle to the fully
open position to release the power supply from the mid plane.
304
To Next Page
Loading...
Need help?
General
