If your system is in… Then…
An HA pair
After the impaired node is displaying the Waiting for
giveback…
message, perform a giveback from the healthy node:
a.
From the healthy node:
storage failover giveback
-ofnode partner_node_name
The impaired node takes back its storage, finishes booting, and
then reboots and is again taken over by the healthy node.
If the giveback is vetoed, you can consider
overriding the vetoes.
ONTAP 9 High-Availability Configuration Guide
b. Monitor the progress of the giveback operation by using the
storage failover show-giveback command.
c. After the giveback operation is complete, confirm that the HA
pair is healthy and that takeover is possible by using the
storage failover show command.
d. Restore automatic giveback if you disabled it using the storage
failover modify command.
18. Exit advanced privilege level on the healthy node.
Boot the recovery image - AFF A320
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
1.
From the LOADER prompt, boot the recovery image from the USB flash drive:
boot_recovery
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the var file system:
415
To Next Page
Loading...
Need help?
General
