appears.
3.
Run diagnostics on the system memory:
sldiag device run -dev mem
4.
Verify that no hardware problems resulted from the replacement of the DIMMs:
sldiag device status
-dev mem -long -state failed
System-level diagnostics returns you to the prompt if there are no test failures, or lists the full status of
failures resulting from testing the component.
5. Proceed based on the result of the preceding step:
If the system-level
diagnostics tests…
Then…
Were completed without
any failures
a.
Clear the status logs:
sldiag device clearstatus
b.
Verify that the log was cleared:
sldiag device status
The following default response is displayed:
SLDIAG: No log messages are present.
c.
Exit Maintenance mode:
halt
The node displays the LOADER prompt.
d.
Boot the node from the LOADER prompt:
bye
e. Return the node to normal operation:
If your node is in an HA pair, perform a give back:
storage failover
giveback -ofnode replacement_node_name
Note: If you disabled automatic giveback, re-enable it with the storage
failover modify
command.
If your node is in a stand-alone configuration, proceed to the next step. No
action is required.
You have completed system-level diagnostics.
56
To Next Page
Loading...
Need help?
General
