1. Use the following animation to set one or more drive shelf IDs:
If your system has NS224 drive shelves, the shelves are pre-set to shelf ID 00 and 01. If you want to
change the shelf IDs, you must create a tool to insert into the hole where button is located.
Setting SAS or NVMe drive shelf IDs
2. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
3. Turn on the power switches to both nodes.
Turn on the power to the controllers
Initial booting may take up to eight minutes.
4. Make sure that your laptop has network discovery enabled.
See your laptop’s online help for more information.
5. Use the following animation to connect your laptop to the Management switch.
Connecting your laptop to the Management switch
6. Select an ONTAP icon listed to discover:
a. Open File Explorer.
b. Click network in the left pane.
c. Right click and select refresh.
d. Double-click either ONTAP icon and accept any certificates displayed on your screen.
XXXXX is the system serial number for the target node.
System Manager opens.
7. Use System Manager guided setup to configure your system using the data you collected in the NetApp
606
To Next Page
Loading...
Need help?
General
