Step 6: Complete battery replacement
Place the controller online, collect support data, and resume operations.
Steps
1. Place controller online.
a. In System Manager, navigate to the Hardware page.
b. Select Show back of controller.
c. Select the controller with the replaced battery.
d. Select Place online from the drop-down list.
2. As the controller boots, check the controller LEDs.
When communication with the other controller is reestablished:
◦ The amber Attention LED remains on.
◦ The Host Link LEDs might be on, blinking, or off, depending on the host interface.
3. When the controller is back online, confirm that its status is Optimal and check the controller shelf’s
Attention LEDs.
If the status is not Optimal or if any of the Attention LEDs are on, confirm that all cables are correctly
seated, and the controller canister is installed correctly. If necessary, remove and reinstall the controller
canister.
If you cannot resolve the problem, contact technical support.
4.
Click Support
› Upgrade Center to ensure that the latest version of SANtricity OS is installed.
As needed, install the latest version.
9
To Next Page
Loading...
Need help?
General
