(1) Power LED. If it is Solid green, the power canister is functioning correctly. If it is Off, the power canister
failed, the AC switch is turned off, the AC power cord is not properly installed, or the AC power cord input
voltage is not within margin (there is a problem at the source end of the AC power cord).
(2) Attention LED. If it is Solid amber, the power canister has a fault, or there is no input power to this
power canister, but the other power canister is operating.
Step 2: Remove failed power canister
Remove a failed power canister so you can replace it with a new one.
Steps
1. Put on antistatic protection.
2. Unpack the new power canister, and set it on a level surface near the shelf.
Save all packing materials for use when returning the failed power canister.
3. Turn off the power switch on the power canister that you need to remove.
4. Open the power cord retainer of the power canister that you need to remove, and then unplug the power
cord from the power canister.
5. Press the orange latch on the power canister cam handle, and then open the cam handle to fully release
the power canister from the mid plane.
6. Use the cam handle to slide the power canister out of the shelf.
When removing a power canister, always use two hands to support its weight.
Step 3: Install new power canister
Install a new power canister to replace the failed one.
Steps
1. Make sure the on/off switch of the new power canister is in the Off position.
2. Using both hands, support and align the edges of the power canister with the opening in the system
chassis, and then gently push the power canister into the chassis using the cam handle until it locks into
place.
40
To Next Page
Loading...
