4
PRE-REQUISITES
If you are using a voice service on
the same line as the DSL service,
you will need a DSL line lter for
each handset or back-to-base
home alarm system on the line. If
you have a Naked DSL service,
line lters are not required.
1. Connect the supplied RJ11 cable to the “modem” port of your DSL line
lter and then connect the other end to the DSL port on the back of the
NF18ACV. Connect the DSL line lter (not included) to the wall socket
and then connect your handset to the “phone” port of the lter. If you
have a Naked DSL service, simply connect the included RJ11 cable
from the DSL port of the NF18ACV to the wall socket. If you have a
VoIP service, connect your handset to one of the Telephone ports on
the back of the router.
2. Connect the supplied RJ45 Ethernet cable from one of the yellow
Ethernet ports (1-4) on the back of the NF18ACV to your computer.
3. Connect the included power adapter to the
Power
jack of the NF18ACV
and then plug it into an available wall socket. Press the
ON/OFF
button
to power the router on. The Power light illuminates in red. When the
NF18ACV has nished booting up, the Power light turns green.
INSTALLING THE DEVICE
VIA DSL CONNECTIONS
To Next Page
Loading...
