NTC-402 – Telstra Private IP WAN Configuration Guide
CG01068 v. 1.0 October 2018
Remote Administrator Host Definition
Separate definitions must be created for HTTP and HTTPS.
Before any changes can be made you must click the Edit button.
T E L S T R A S E T T I N G S
System generated reference number.
To access the broadest range of web services, create one definition for
HTTP and one for HTTPS.
Any IP allows unlimited access to all URLs using the selected Protocol.
If you select Specific IP enter its IP address in the filed provided. You
must create a separate Host Definition for each specific address.
This is unnecessary (N/A) if the IP is set to Any IP.
For each Specific IP address, select an appropriate Subnet Mask from
the drop down menu.
For HTTP the default port is: 80
For HTTPS the default port is: 443
For HTTP: 80
For HTTPS: 443
Select Enable to activate the definition.
Click the Edit button to enable changes to the definition.
Table 5 – Remote Administrator configuration
12 Click the Save button to apply the changes you have made.
Enable Telnet, SSH and HTTP/S WAN
13 Open Administration >> Configure & Manage and click the Telnet & SSH tab:
Figure 6 – Telnet & SSH settings
14 For Telnet make the following settings:
a Select LAN Enable
b Select WAN Enable
c Set the Service Port to 23
15 For SSH (Secure SHell) make the following settings:
a Select LAN Enable
To Next Page
Loading...
Need help?
General
