ADT Pulse Wi-Fi Range Extender
https://alpha.adt.com/help/108[11/12/2018 10:11:06 PM]
6. Enter the MAC ID number in the space provided. Do not click the Continue button at this time. If you
click Continue before its ready, the process will fail. Wait for the time-out to occur naturally, or click Go
Back, then Confirm the pop-up and then repeat steps 4-6.
7. Use a standard Ethernet cable to temporarily connect the new Wi-Fi Extender to the device LAN port
of the ADT Pulse Gateway or Total Security (TS) Base unit. You will be able to relocate the device when the
enrollment is complete.
8. Temporarily plug the Wi-Fi Extender into a wall outlet that is close to the ADT Pulse Gateway.
9. Wait for the power LED on the device to turn solid green, and then click Continue .
To Next Page
Loading...
Need help?
General