Factory Default Settings
To reset the extender to factory default settings, you can use the Reset button on the
side panel or you can log in and click the onscreen RESET button. For more information,
see Return the extender to its factory default settings on page 56.
The following table shows the factory default settings.
Table 10. Factory default settings
Default SettingsFeature
EnabledSmart Setup
EnabledWiFi communication
NETGEAR_EXTWiFi network name (SSID)
DisabledSecurity
Auto
1
Transmission speed
Varies by regionCountry/region
802.11a/b/g/n/ac/axOperating mode
Max 600 MbpsData rate in the 2.4 GHz band
Disabled by default
(When enabled the max data rate is 1200 Mbps)
Data rate in the 5 GHz band
Server and client are enabledDHCP
1
Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and environmental
factors, including volume of network traffic, building materials and construction, and network overhead lower actual
data throughput rate.
User Manual70Supplemental Information
AX1800 4-Stream WiFi 6 Mesh Extender
To Next Page
Loading...
Need help?
General
