NETGEAR Certified Refurbished C6300-100NAR DOCSIS
3.0 WiFi Cable Modem Router with AC1750 16x4 download
speeds. Certified for Xfinity from Comcast, Spectrum, Cox,
Cablevision & more
Scenario 1: You are using a standalone Cable/DSL modem with a router.
1. Turn off or shut down all your networking devices (Cable/DSL modem, Wired/Wireless router,
and Wired & Wireless devices).
Note: Some modems are equipped with a backup battery. If your modem has one, please
remove the backup battery to completely turn off your modem. For common cable modems
equipped with backup batteries, please see Performing a full reset of cable modem with battery
backup
2. Turn on the Cable/DSL modem first and let it boot up. This will take a couple of minutes while
the modem is syncing with your ISP to establish a connection. In most cases all the LED lights will
remain stable, however, always refer to the user manual of the modem to verify the status of
the LED lights.
3. Once the Cable/DSL modem completes the connection to your ISP, turn on the Wired/Wireless
router. The router will now establish a connection with the Cable/DSL modem. This process will
take a few minute as well. In most cases, the Internet LED light on the router will turn solid
green, however, please refer to the user manual of the router to verify the status of the LED
lights.
4. Turn ON your wired & wireless devices.
To Next Page
Loading...
Need help?
General
