Prepare for Installation
Before installing the CM212 cable modem, you should have active (two-way) cable
service and an Internet account with your cable provider.
Note: If you’re connecting a single computer to the modem, you may use either the
modem’s USB or Ethernet port. If you’re connecting more than one computer, you
must use the Ethernet port combined with a Router.
USB Connection
If you’re connecting the modem to one computer using the USB port, you must have:
• Windows
®
98 Second Edition, Me, 2000, or XP.
• An available USB port in the computer.
• A USB cable.
Note: There is one USB cable in the box with the cable modem.
Ethernet Connection
If you’re connecting the modem to one or more computers, for each computer you must have:
• An available RJ-45 Ethernet port (or adapter) – either built-in or from a network
interface card (NIC) installed on the PC.
• TCP/IP networking installed.
• Windows
®
computers: Client for Microsoft
®
Networks software installed.
Note: TCP/IP and Client for Microsoft Networks is installed on most Windows
computers. Please see Windows Help if you need help installing either on a
Windows computer.
• A Category 5 (Cat 5) Ethernet patch cable.
Note: There is one cable in the box with the cable modem.
Additionally, if you want to connect more than one computer to the modem, you need:
• A Ethernet router, hub, or switch (for example, RP614 Cable/DSL Web Safe Router
Gateway).
Note: If using a hub or switch, you may need to get additional IP addresses from
your ISP.
1
1
3
To Next Page
Loading...
Need help?
General
