NETGEAR EX2700 Installation Guide

5
Install the WiFi Extender
Place the extender, apply power, and connect it to your WiFi network.
Place the Extender and Apply Power
1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
The Power LED lights green. If the Power LED does not light, press the
Power button.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see Connect with WPS on
page 6
.
• Connect with web browser setup. For more information, see
Connect with Web Browser Setup on page 7.

NETGEAR EX2700 Specifications

General

Type	Network repeater
Maximum transfer distance	- m
External power adapter	No
On/off switch	Yes
Product color	White
LED indicators	Power, WPS
Antennas quantity	2
Bandwidth	2.4 GHz
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100Base-T(X)
Security algorithms	WEP, WPA, WPA2-PSK
Ethernet LAN (RJ-45) ports	1

Weight and Dimensions

Depth	34 mm
Width	55 mm
Height	67 mm
Weight	98 g