NETGEAR EX6400 Quick Start

11
Connect an Ethernet-Enabled Device
After the extender is connected to your existing WiFi network, you can
connect a wired device to the extender using an Ethernet cable. That
device can then access your existing network through the WiFi connection.
Use the Extender in Access Point Mode
You can set up your extender as a WiFi access point. Tri-band WiFi is
available when your extender is in access point mode.
The following instructions assume that you did not previously set up your
extender.

NETGEAR EX6400 Specifications

General

Power plug	-
Ethernet LAN	Yes
Wi-Fi standards	Wi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Top Wi-Fi standard	Wi-Fi 5 (802.11ac)
Security algorithms	WEP, WPA, WPA2-PSK
Networking standards	IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Built-in power socket	No
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN (RJ-45) ports	1
Ethernet LAN interface type	Gigabit Ethernet
WLAN data transfer rates supported	1900 Mbit/s
Product color	White
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	81.4 mm
Width	161 mm
Height	44.5 mm
Weight	300 g