ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
1-6 Introduction
v1.0, October 2007
– ProSafe VPN Client Software – one user license.
• Warranty and Support Information Card.
If any of the parts are incorrect, missing, or damaged, contact your NETGEAR dealer. Keep the
carton, including the original packing materials, in case you need to return the firewall for repair.
Front Panel Features
The ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN front panel shown below
includes four groups of status indicator light-emitting diodes (LEDs), including Power and Test,
WAN1, WAN2, and the LAN lights:
The function of each LED is described in the following table:
Figure 1-1
Table 1-1. LED Descriptions
Object Activity Description
PWR
(Power)
On (Green)
Off
Power is supplied to the VPN firewall.
Power is not supplied to the VPN firewall.
TEST On (Amber)
Blinking (Amber)
Off
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
WAN Ports
ACTIVE On (Green)
On (Amber)
Off
The WAN port has a valid Internet connection.
The Internet connection is down or not being used because the port
is in standby for failover.
The WAN port is either not enabled or has no link.
SPEED On (Green)
On (Amber)
Off
The LAN port is operating at 1,000 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.
To Next Page
Loading...
Need help?
General
