NETGEAR GS348 User Manual

Installation
ProSAFE 48-port Gigabit Unmanaged
Ethernet Rackmount Switch
Model GS348
Step 1: Install the Switch
You can install the switch on a flat surface or in a rack. For information
about how to rack-mount the switch, see Rack-Mount the Switch on the
other side of this document.
¾ To install the switch on a flat surface:
1. Attach the rubber feet that came in the package with the switch.
2. Make sure that the switch is positioned with at least 2 inches of
space on all sides for ventilation.
Step 2: Connect Devices
Package Contents
Power cord
(localized to
the region)
Rack-mount kit
Rubber
feet
GS348
switch
Installation guide
(this document)
Step 3: Connect Power
Step 4: Check the Status
Power LED Port LEDs (Ports 1–48)
On 1000 Mbps link
O 100 or 10 Mbps link
Activity (blinking)
No link (o)

NETGEAR GS348 Specifications

General

Switch type	Unmanaged
Quality of Service (QoS) support	Yes
Power connector	DC-in jack
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	-
Form factor	1U
Product color	Black
LED indicators	Activity, Link, Power
Jumbo frames	9216
Latency (1 Gbps)	4 µs
MAC address table	16000 entries
Packet forwarding rate (1 Gbps)	1448000 pps
10G support	No
Networking standards	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Power source	AC
Input current	1 A
AC input voltage	110 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	23 W
Power consumption (typical)	8.81 W
Heat dissipation	7866 BTU/h
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	204 mm
Width	440 mm
Height	43.2 mm
Weight	3150 g

Summary

Installation Guide

Install the Switch

Instructions for installing the switch on a flat surface, including attaching rubber feet and ensuring adequate ventilation space.

Connect Devices

Diagram illustrating how to connect various devices to the switch for network connectivity.

Connect Power

Step detailing the process of connecting the power supply to the switch.

Check Status Indicators

Explanation of Power and Port LED status lights for network activity and link status.

Package Contents

Rack-Mount the Switch

Specifications

Support Information