NETGEAR Nighthawk AX6 Series User Manual

Cable your router
Power on your router and connect it to a modem.
Figure 7. Cable your router
To cable your router:
1.
Unplug your modem, remove and reinsert the backup battery if it uses one, and
then plug the modem back in.
2. Use the Ethernet cable to connect the modem to the yellow Internet port on the
router.
Note: If your Internet connection does not require a modem, connect your main
Ethernet cable to the yellow Internet port on the router.
3. Connect the power adapter to your router and plug the power adapter into an outlet.
4.
Press the Power On/Off button on the rear panel of the router.
The router’s Power LED lights solid white when the router is ready.
User Manual16Hardware Setup
Nighthawk AX6 6-Stream AX4300 WiFi Router

NETGEAR Nighthawk AX6 Series Specifications

General

Beamforming	Yes
MU-MIMO	Yes
Model	RAX50
OFDMA	Yes
Processor	1.5 GHz quad-core
USB Ports	1 x USB 3.0
Security	Supports WPA3
Memory	512MB DDR3 RAM
WiFi Technology	Wi-Fi 6 (802.11ax)
Antenna	4 x external antennas