NETGEAR Nighthawk R6700 User Manual

103
10
10. Specify Network Settings
The router comes ready for WiFi, Ethernet, and USB connections. You can customize the
router’s network settings. NETGEAR recommends that you install the router and connect it to the
Internet before you change its network settings.
This chapter includes the following sections:
• Disable LED Blinking or Turn Off LEDs
• View WAN Settings
• Set Up a Default DMZ Server
• Change the Router’s Device Name
• Change the LAN TCP/IP Settings
• Specify the IP Addresses That the Router Assigns
• Disable the DHCP Server Feature in the Router
• Reserve LAN IP Addresses
• Use the WPS Wizard for WiFi Connections
• Specify Basic WiFi Settings
• Change the WiFi Security Option
• Set Up a Guest Network
• How the Router Manages Wireless Clients
• Control the Wireless Radios
• Set Up a Wireless Schedule
• Specify WPS Settings
• Use the Router as a Wireless Access Point
• Set Up the Router in Bridge Mode
• Set Up a Wireless Distribution System

NETGEAR Nighthawk R6700 Specifications

General

WiFi Speed	AC1750 (450 + 1300 Mbps)
USB Ports	1 x USB 3.0
Antenna	3 external antennas
Beamforming	Yes
Wireless Standard	802.11a/b/g/n/ac
Operating Temperature	32°F to 104°F (0°C to 40°C)
WiFi Technology	802.11ac
Ethernet Ports	4 x Gigabit Ethernet
Frequency Band	2.4 GHz and 5 GHz
Memory	128 MB Flash, 256 MB RAM
Security	WPA2-PSK
Dimensions	11.22 x 7.26 x 1.97 inches
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Processor	1GHz Dual Core Processor