NETGEAR Nighthawk R7450 User Manual

If all LEDs are still lit one minute after power-up, do the following:
•
Cycle the power to see if the router recovers.
•
Press and hold the Reset button to return the router to its factory settings.
If the error persists, a hardware problem might be the cause. Contact Technical Support
at netgear.com/support.
Internet or Ethernet LAN port LEDs are off
If the Internet LED or Ethernet LAN port LEDs do not light when an Ethernet connection
is made, check the following:
•
Make sure that the Ethernet cable connections are secure at the router and at the
modem or computer.
•
Make sure that power is turned on to the connected modem or computer.
•
Be sure that you are using the correct cable.
When you connect the router’s Internet port to a modem, use the cable that was supplied
with the modem. This cable can be a standard straight-through Ethernet cable or an
Ethernet crossover cable.
WiFi LED is off
If the WiFi LED stays off, check to see if someone pressed the WiFi On/Off button on
the router. This button turns the WiFi radios in the router on and off. If someone disabled
the WiFi radios by using the router web interface, the WiFi LED also stays off. The WiFi
LED is lit when the WiFi radios are turned on.
You cannot log in to the router
If you are unable to log in to the router from a computer or mobile device on your local
network, check the following:
•
If you are using an Ethernet-connected computer, check the cable connection
between the computer and the router.
•
If you are using a WiFi-enabled computer or mobile device, check the WiFi connection
between the computer or mobile device and the router.
•
Make sure that you are using the correct login information. The user name is admin.
The password is the one that you specified the first time that you logged in. (The
default password is password.) The user name and password are case-sensitive.
Make sure that Caps Lock is off when you enter this information.
User Manual144Troubleshooting
Nighthawk AC2600 Smart WiFi Router Model R7450

NETGEAR Nighthawk R7450 Specifications

General

Beamforming+	Yes
MU-MIMO	Yes
VPN Support	Yes
Parental Controls	Yes
Guest Network	Yes
WiFi Technology	802.11ac Dual Band
WiFi Performance	AC2600 (800 Mbps + 1733 Mbps)
Ethernet Ports	5 x 10/100/1000 Mbps Gigabit Ethernet ports
USB Ports	1 x USB 3.0
Processor	Dual Core
Memory	256MB RAM
Antenna	3 external antennas
Dimensions	11.22 x 7.26 x 1.97 inches