The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Setup > Device Name.
The Device Name page displays.
5.
In the Device Name field, type a new name.
6.
Click the Apply button.
Your settings are saved.
Change the LAN IP or RIP settings
The router is preconfigured to use private IP addresses on the LAN side and to act as
a DHCP server. The router’s default LAN IP configuration is as follows:
•
LAN IP address: 192.168.1.1
•
Subnet mask: 255.255.255.0
These addresses are part of the designated private address range for use in private
networks and are suitable for most applications. If your network requires a different IP
addressing scheme, you can change these settings.
You might want to change these settings if you need a specific IP subnet that one or
more devices on the network uses, or if you use competing subnets with the same IP
scheme.
Router Information Protocol (RIP) allows a router to exchange routing information with
other routers. You can change the RIP settings.
To change the LAN IP or RIP settings:
1.
Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2.
Enter orbilogin.com.
A login window displays.
3.
Enter the admin user name and password.
User Manual85Specify Network Settings
Whole Home Quad-Band Mesh WiFi 7 System
To Next Page
Loading...
Need help?
General
