Introduction
Thank you for purchasing a NETGEAR PS101
Mini Print Server. With this print server you can
share your printer with all the computers in your
home or office that run Microsoft® Windows®
95 OSR2, 98, 2000, NT 4.x, Me, or XP
operating system.
This installation guide shows you how to connect
the print server to your printer and configure it to
use with your computers. Setup is easy – if you
follow the instructions in this guide, the print server
will soon be up and running for your computers.
If you have problems, there is a troubleshooting section on page 9 to help you. You can get
more detailed troubleshooting information from the Reference Manual on the CD or online at
www.NETGEAR.com in our Support section.
Installation Procedure Overview
Estimated time: 30 minutes
1. Unpack the box and verify the contents.
2. Connect the print server to the printer and to the network.
3. Configure the print server to be recognized on the network.
4. Configure each computer to print through the print server.
Note: You only need to go through procedures 1 through 3 once. Repeat procedure
4 for each computer that will share the printer with the print server. It takes less
than 5 minutes to configure and test each computer.
On the PS101 Resource CD, you will find a Reference Manual containing more detailed
information about installation, troubleshooting and configuration.
1
To Next Page
Loading...
Need help?
General
