Configure a Computer To Access the
Print Server
Before using the PS101 on your network, each computer that needs to access the print server
must have:
• A connection to the network.
• The printer added using the NETGEAR Add Printer Wizard.
• Either the printer driver software already installed or, if this is a new printer, access to the
printer driver software (either on a CD or downladed to a disk).
To install the Add Printer Wizard (for a non-administrative
computer):
Note: You can skip ahead “To configure
computers...” if you have already installed the
NETGEAR software on this computer.
1. Insert the PS101 Printer Server Resource CD in
the CD-ROM drive. NETGEAR Print Server
Software Installation wizard starts up
automatically. If it doesn’t, double-click My
Computer, double-click your CD-ROM drive,
and double-click Setup.exe.
2. Follow the instructions in the installation wizard to
install the software.
3. When asked, select only the NETGEAR Add Printer Wizard.
4. Click Finish.
6
4
4
To Next Page
Loading...
