Install Printer Server Software and
Setup the Print Server
The PS101 comes with several software components that allow you to set up the
print server and use administrative tools. You should install all the software onto one Windows
computer to act as the print server administrator. For the other computers, only install the
NETGEAR Add Printer Wizard as described in procedure 4.
To install the NETGEAR Print Server software:
1. Insert the PS101 Printer Server Resource CD in
the CD-ROM drive. NETGEAR Print Server
Software Installation wizard starts up
automatically. If it doesn’t, double-click My
Computer, double-click your CD-ROM drive,
and double-click Setup.exe.
2. Follow the instructions in the installation wizard
to install the software.
3. For the administrative computer, install all components.
Note: If this computer will just use the printer, only select the NETGEAR Add
Printer Wizard. See procedure 4:
Configure a Computer To Access the Print Server
for details.
4. Click Finish.
To set up the print server:
1. Click Start. Point to Programs and click NETGEAR Print Server>NETGEAR Print Server
Setup Wizard.
2. Follow the instructions in the installation wizard to set up the print server.
\If you have questions, click Help for information about a specific screen.
4
3
3
To Next Page
Loading...
Need help?
General
