NETGEAR PS121 User Manual (English)

Other manuals for NETGEAR PS121

User Manual45 pages

Start Here2 pages

Specification Sheet2 pages

Questions and Answers:

M
mitchellemilyAug 9, 2025
How to fix NETGEAR Print Server IP address conflict with DHCP server?
- K
  Kendra CampbellAug 9, 2025
  If your Mini Print Server gets an IP Address conflict while using a DHCP server, it could be because the mini print server was left on when the DHCP server was turned off. In this case, reset the mini print server to obtain a new IP Address. This issue can also occur if you assigned a static IP Address within the range used by the DHCP server; use another address NOT within the range used by the DHCP server.
R
Rhonda GonzalezAug 14, 2025
Why is nothing printing from my NETGEAR PS121 Print Server?
- V
  Vanessa MendozaAug 14, 2025
  If nothing is printing, first try printing from another computer to determine if the issue lies with your computer configuration rather than the print server. You can also try turning the print server off and then on again to see if that resolves the issue. If the printer does not match the printer driver in the operating system, run the Add Printer Wizard. Also, try disabling the printer's bidirectional feature, if it is turned on.
P
paul51Aug 25, 2025
How to resolve 'garbage' characters printing from NETGEAR PS121?
- H
  Heather SmithAug 25, 2025
  If your printer is printing 'garbage' characters, the printer may not match the printer driver in the operating system. To resolve this, run the Add Printer Wizard.
B
brentandersonAug 29, 2025
How to troubleshoot NETGEAR mini Print Server with no power?
- J
  jason34Aug 29, 2025
  If the mini print server has no power, ensure the power cord is correctly connected to the mini print server and that the power adapter is connected to a functioning power outlet, verifying the power strip is on if applicable, or that it is not a switched outlet if plugged directly into the wall. Also, confirm that you are using the correct NETGEAR power adapter supplied with your mini print server.
Z
Zachary LoweSep 3, 2025
How to verify NETGEAR PS121 wrong network configuration?
- J
  Jamie StewartSep 3, 2025
  To verify a wrong network configuration, check that the IP address for your mini print server and your workstation are correct and that the addresses are on the same subnet.

NETGEAR PS121 Specifications

General

Device Type	Print Server
Brand	NETGEAR
Model	PS121
Wireless	No
Data Link Protocol	Ethernet
Connectivity Technology	Wired
Data Transfer Rate	100 Mbps
Form Factor	External
Interface	USB
Network Interface	Ethernet
Supported Protocols	TCP/IP
Compatibility	Mac, Linux

Related product manuals

PS121 - USB Mini Print Server

NETGEAR PS121 Installation Guide

Table of Contents

Other manuals for NETGEAR PS121

Questions and Answers:

NETGEAR PS121 Specifications

Related product manuals