Table 1. LED descriptions
DescriptionLED and Button
•
Solid green. The router is ready.
•
Solid amber. The router is starting.
•
Blinking amber. The router is not ready, firmware is upgrading, or the Reset
button was pressed.
•
Off. Power is not supplied to the router.
Power LED
•
Solid green. The Internet connection is ready.
•
Blinking green. The port is sending or receiving traffic.
•
Solid amber. An Ethernet cable is connected to the Internet port but Internet
is not accessible.
•
Off. No Ethernet cable is connected between the router and the modem.
Internet LED
•
Solid green. The WiFi radios are on. You can connect to the router's WiFi
network.
•
Off. The WiFi radios are turned off and you cannot use WiFi to connect to the
router.
WiFi LED
•
Solid green. The router detected a 1 Gbps link with a device that is connected
to one of the router's Ethernet ports.
•
Solid Amber. The router detected a 10/100 Mbps link with a device that is
connected to one of the router's Ethernet ports.
•
Blinking green. One of the router's Ethernet ports is sending or receiving
traffic at 1 Gbps.
•
Blinking amber. One of the router's Ethernet ports is sending or receiving
traffic at 10/100 Mbps.
•
Off. No device is connected to an Ethernet port.
Ethernet LED
Pressing the WPS button on the back of the router lets your WPS-enabled device
join your router's WiFi network without typing the WiFi password. The WPS LED
blinks green during the WPS process and then lights solid green when the
WPS-enabled device connects to your router's WiFi network.
WPS LED
User Manual11Hardware Setup
4-Stream AX1800 WiFi 6 Router
To Next Page
Loading...
Need help?
General
