EasyManuals Logo

NETGEAR RAX70 User Manual

NETGEAR RAX70
175 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
3.
If you do not receive replies, check the following:
Check to see that IP address of your router is listed as the default gateway for
your computer. If DHCP assigns the IP configuration of your computers, this
information is not visible in your computer Network Control Panel. Verify that the
IP address of the router is listed as the default gateway.
Check to see that the network address of your computer (the portion of the IP
address specified by the subnet mask) is different from the network address of
the remote device.
Check to see that your cable or DSL modem is connected and functioning.
If your ISP assigned a host name to your computer, enter that host name as the
account name on the Internet Setup page.
Your ISP might be rejecting the Ethernet MAC addresses of all but one of your
computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address
of your broadband modem. Some ISPs additionally restrict access to the MAC address
of a single computer connected to that modem. If your ISP does this, configure your
router to “clone” or “spoof” the MAC address from the authorized computer.
User Manual171Troubleshooting
Nighthawk AX8 8-Stream Tri-Band WiFi 6 Router

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR RAX70 and is the answer not in the manual?

NETGEAR RAX70 Specifications

General IconGeneral
WiFi SpeedUp to 6.6Gbps
WiFi BandsTri-Band
USB Ports1 x USB 3.0
BeamformingYes
MU-MIMOYes
OFDMAYes
WiFi Technology802.11ax
ProcessorQuad-Core 1.5 GHz
Antennas6
SecurityWPA3
Memory512MB RAM
Ethernet Ports5 (1 x 2.5 Gbps WAN, 4 x 1 Gbps LAN)

Related product manuals