NETGEAR RAX70 User Manual

Top panel LEDs and buttons
The status LEDs and two buttons are located on the top panel of the router.
Figure 2. Top view
Table 1. LED descriptions
DescriptionLED and Button
Solid white. The router is ready.
Blinking white. The router is not ready, firmware is upgrading, or the Reset
button was pressed.
Off. Power is not supplied to the router.
Power LED
Solid white. The Internet connection is ready.
Blinking white. The port is sending or receiving traffic.
Off. No Ethernet cable is connected between the router and the modem.
Internet LED
Solid white. The 2.4 GHz WiFi radio is operating.
Blinking white. The router is sending or receiving WiFi traffic.
Off. The 2.4 GHz WiFi radio is off.
2.4 GHz WiFi LED
User Manual11Hardware Setup
Nighthawk AX8 8-Stream Tri-Band WiFi 6 Router

NETGEAR RAX70 Specifications

General

WiFi Speed	Up to 6.6Gbps
WiFi Bands	Tri-Band
USB Ports	1 x USB 3.0
Beamforming	Yes
MU-MIMO	Yes
OFDMA	Yes
WiFi Technology	802.11ax
Processor	Quad-Core 1.5 GHz
Antennas	6
Security	WPA3
Memory	512MB RAM
Ethernet Ports	5 (1 x 2.5 Gbps WAN, 4 x 1 Gbps LAN)