NETGEAR RAX70 User Manual

Cable your router
Power on your router and connect it to a modem.
Figure 7. Cable your router
To cable your router:
1.
Unplug your modem, remove and reinsert the backup battery if it uses one, and
then plug the modem back in.
2. Use the Ethernet cable to connect the modem to the yellow Internet port on the
router.
Note: If your Internet connection does not require a modem, connect your main
Ethernet cable to the yellow Internet port on the router.
3. Connect the power adapter to your router and plug the power adapter into an outlet.
4.
Press the Power On/Off button on the rear panel of the router.
The router’s Power LED lights solid white when the router is ready.
User Manual17Hardware Setup
Nighthawk AX8 8-Stream Tri-Band WiFi 6 Router

NETGEAR RAX70 Specifications

General

WiFi Speed	Up to 6.6Gbps
WiFi Bands	Tri-Band
USB Ports	1 x USB 3.0
Beamforming	Yes
MU-MIMO	Yes
OFDMA	Yes
WiFi Technology	802.11ax
Processor	Quad-Core 1.5 GHz
Antennas	6
Security	WPA3
Memory	512MB RAM
Ethernet Ports	5 (1 x 2.5 Gbps WAN, 4 x 1 Gbps LAN)