NETGEAR ReadyNAS 4312

To access the boot menu:
1.
Power off your system.
2. Using a straightened paper clip, press and hold the Reset button on the control
panel.
3.
Press and continue pressing the Power button on the front panel of the system until
the system powers on and either the Power LED stops blinking or the Power, UI, and
Health LEDs are lit.
Note: It takes approximately one minute for the system to enter boot mode.
4.
Press and hold the Reset button, releasing after about one second, to scroll through
the boot menu modes.
The storage system shows the boot mode options using the LEDs, as described in
the following table:
Status IndicatorBoot Mode
Power
LED
UI LEDHealth
LED
Description
Power, UI, and Health LEDs blink.Boot menu
Health LED lights.Normal
UI LED lights.Factory default
UI and Health LEDs light.OS reinstall
Power LED lights.Tech support
Power and Health LEDs light.Volume read only
Power and UI LEDs light.Memory test
Power, UI, and Health LEDs light.Test disk
Legend:
•
Solid:
•
Blinking:
•
Off:
Hardware Manual45ReadyNAS 3138
ReadyNAS OS 6