NETGEAR ReadyNAS 4312

Status Information
You can obtain information about the status of your system by reviewing the indicators
listed in the following table.
Table 5. Status indicators
DescriptionIndicator
The Power LED indicates these states:
•
Green. The system is powered on.
•
Amber. The system is in standby mode.
•
Off. The system is powered off.
Power LED (control panel)
The UI LED indicates these states:
•
Blue. The system is identified: The UI button was pressed and the UID
LED on the rear panel is lit.
•
Off. The system is not identified.
UI LED (control panel)
The Health LED indicates these states:
•
Red. The system needs attention. Use the local admin page to determine
the problem. For more information, see the ReadyNAS OS 6.5 Software
Manual, which is available at
http://support.netgear.com/product/ReadyNAS-OS6.
•
Off. The system is healthy.
Health LED (control panel)
The LAN LEDs indicate these states:
•
Green. An Ethernet cable is connected.
•
Blinking. The Ethernet link is active.
•
Off. There is no Ethernet connection.
LAN LEDs (control panel)
The top LED indicates disk status, as follows:
•
On. A disk is present.
•
Off. No disk is present.
The bottom LED indicates disk activity as follows:
•
Blinking. The disk is active.
•
Off. There is no disk activity.
•
Blinking on/off/on/off pattern. The disk failed or is faulty.
Disk LEDs (disk trays)
Hardware Manual52ReadyNAS 3220 and 4220
ReadyNAS OS 6