NETGEAR ReadyNAS 4312

To migrate a volume to a diskless ReadyNAS OS 6 system:
1.
Gracefully shut down the new (diskless) storage system.
For information about how to gracefully shut down your system, see the Preferred
Shutdown section of the chapter that describes your system.
2.
Remove each disk in the volume from the old system.
3. Install each disk in the volume into the new storage system.
For more information, see Add a Disk on page 82.
4. Turn on the new system by pressing the Power button.
The new system recognizes the migrated volume and its data.
Add a Disk
You can add a 3.5-inch hard disk drive, 2.5-inch hard disk drive, or a 2.5-inch solid-state
drive to an empty disk bay.
If you want to add a previously formatted disk to your storage system, see the instructions
in Previously Formatted Disks on page 80.
Hardware Manual82Disks
ReadyNAS OS 6