NETGEAR WAC720

Advanced Configuration
123
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Figure 6. Point-to-point WiFi network
• WiFi point-to-multipoint bridge. The access point is the master for a group of
bridge-mode access points. You can configure up to four WiFi bridges.
The other bridge-mode WiFi access points must be set to point-to-point bridge mode,
using the MAC address of the your access point (that is, the master). Rather than
communicating directly with each other, all other bridge-mode access points send their
traffic to the master access point. You can use WPA2-PSK to secure the communication.
Figure 7. Point-to-multipoint WiFi network
WiFi client
WiFi client
Internet
AP1 in
point-to-point
bridge mode
AP2 in
point-to-point
bridge mode
LAN segment 1
LAN segment 2
WiFi client
WiFi client
AP2 in
point-to-point
bridge mode
Master AP1 in
point-to-point
bridge mode with
AP3 in
point-to-point
bridge mode
both AP2 an AP3
Internet
LAN segment 1
LAN segment 2
LAN segment 3