Need help?Do you have a question about the NETGEAR WAX214 and is the answer not in the manual?
General| DC-in jack | Yes |
|---|---|
| USB 2.0 ports quantity | 0 |
| Ethernet LAN (RJ-45) ports | 1 |
| Power supply | 18 W |
| Input current | 1.5 A |
| AC input voltage | 12 V |
| Cables included | LAN (RJ-45) |
| Number of products included | 1 pc(s) |
| Placement | Ceiling, Table, Wall |
| Certification | CB, EN60950, EN62368 |
| Product color | White |
| LED indicators | LAN, Power, WLAN |
| Cable lock slot type | Kensington |
| Storage temperature (T-T) | 0 - 95 °C |
| Operating temperature (T-T) | -40 - 70 °C |
| Storage relative humidity (H-H) | 5 - 95 % |
| Operating relative humidity (H-H) | 0 - 40 % |
| Number of users | 128 user(s) |
| Networking standards | IEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11n |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Maximum data transfer rate | 1773.5 Mbit/s |
| Maximum data transfer rate (5 GHz) | 1201 Mbit/s |
| Maximum data transfer rate (2.4 GHz) | 573.5 Mbit/s |
| Antenna type | Internal |
| Antenna gain level (max) | 4 dBi |
| Security algorithms | WPA2, WPA3 |
| Number of SSID supported | 4 |
| Harmonized System (HS) code | 85176990 |
Weight and Dimensions| Width | 160.9 mm |
|---|---|
| Height | 33.28 mm |
| Weight | 380 g |
Provides essential safety guidelines and precautions for indoor use and handling of the access point.
Guides on connecting the access point to your network via PoE or non-PoE methods.
Outlines the steps for the initial login and configuration of the access point.
Instructions for connecting wirelessly for the initial setup and login.
Instructions for connecting via wired LAN for the initial setup and login.
Guide on how to log in to the access point's UI after the initial setup is done.
How to assign a fixed IPv4 address to the access point for network management.
Steps to set up SSIDs with personal security like WPA2/WPA3.
Guides on setting up SSIDs using WPA2/WPA3 enterprise security with RADIUS.
How to set up a separate guest network on an SSID for limited access.
Steers dual-band WiFi devices to the optimal 2.4 GHz or 5 GHz band.
Controlling bandwidth usage for SSIDs or individual users to manage network traffic.
Instructions for updating the access point's firmware to the latest version.
Procedures for backing up and restoring the access point's configuration settings.
How to reset the access point to its original factory default configuration.
Steps to change the password used to log in to the access point's local browser UI.
Viewing detailed information about the access point's hardware, memory, and network status.
Testing network connectivity to a specified IP address or domain name.
General advice and common checks for resolving WiFi connectivity problems.
Interpreting the status of LEDs on the access point for troubleshooting.
Detailed steps to resolve issues where WiFi devices cannot connect or have poor connectivity.
Diagnosing problems when WiFi devices are connected but cannot access the Internet.
Steps to troubleshoot and resolve issues preventing login via a wired LAN connection.
Using ping to test network paths and diagnose connectivity issues from your computer.
To Next Page
