NETGEAR WAX214

Note: To unlock the access point, push the locking tab toward the ceiling and slide the
access point out of the bracket. The following figure shows a side view of the access
point attached to the ceiling. The green arrow indicates the locking tab.
Mount model WAX214 to a T-bar
To mount the access point to a T-bar:
1. Slide the 15/16 in. (23.8 mm) bracket between the guides on the bottom the access
point until it locks in place.
The locking tab must be at the front of the access point.
2. Hold the access point upside down.
User Manual145Mount Model WAX214 to a Wall
or Ceiling
NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218