Mount model WAX218 to a wall
To mount the access point to a wall:
1.
The bottom of the access point includes two holes that let you mount the access
point on two screws inserted in a wall.
2. Mark the wall where you want to insert the provided anchors and screws, which must
be 4.33 in. (110 mm) apart.
3.
Insert the anchors and screws, but leave about 0.25 in. (6 mm) of each screw
protruding from the wall so that you can insert the screws into the holes on the
bottom of the access point.
User Manual148Mount Model WAX218 to a Wall
or Ceiling
NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
To Next Page
Loading...
