(Continued)
DescriptionField
The operation mode is AP. For more information about the changing the operation
mode, see Change the operation mode to AP mode or router mode on page 113.
Operation Mode
The usage load on the CPUsCPU Load
The RAM memory that is being used and the available memory.Memory Usage (Used/Total)
The time elapsed since the AP was last restarted.System Uptime
DescriptionField
LAN Port
You cannot change these settings when the AP operates in AP mode.
The MAC address that applies to the AP WAN (Internet) port.MAC Address
Displays if the DHCP client of the AP is enabled.DHCP
The LAN IP address that the AP receives from an existing router in your network
or the static (fixed) IP address that you manually configured.
IP Address
The IP subnet mask that the AP uses.IP Subnet Mask
The IP address of the gateway to which the AP connects to the Internet.Gateway IP Address
The IP address of the Domain Name System (DNS) server that the AP uses.Domain Name Server
DescriptionField
Wireless Settings (2.4 GHz) or Wireless Settings (5.0 GHz )
To change these settings, see Basic WiFi and Radio Features on page 48 and Advanced WiFi and Radio Features
on page 117.
The name of the SSID (see Set up or change an open or secure WiFi network on
page 49).
Name
The country and region in which the AP is being used (see Change the region of
operation on page 118).
Region
The channel that the radio uses (see Change the channel for a radio on page 123).Channel
The WiFi throughput mode that the radio uses (see Change the WiFi throughput
mode on model WAX202 on page 124).
Mode
User Manual107Maintain and Monitor
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
To Next Page
Loading...
