Back panel
The back panel of the AP provides Gigabit Ethernet ports, a Reset button, and a DC
power connector.
Figure 2. Back panel, model WAX202
Viewed from top to bottom, the back panel of model WAX202 contains the following
components:
•
Reset button. Press the Reset button to reset the AP to factory default settings. For
more information, see Use the Reset button to return the AP to factory defaults on
page 97.
•
WAN port. One Gigabit (1 Gbps) Ethernet port with a yellow label that functions as
a WAN (Internet) port to connect the AP to a modem, a router, or an Ethernet wall
outlet that provides Internet service:
- Connect to a modem: Connect the WAN port directly to a broadband, cable,
or DSL device that is a modem. The modem must provide an Internet connection
to the AP. For more information about this setup, in which the AP must function
User Manual16Hardware Overview Model
WAX202
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
To Next Page
Loading...
