If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > Set Password.
The Set Password page displays.
5. Make sure that the Enable Password Reset check box is selected.
This check box is selected by default.
6. Select two security questions and provide answers to them.
7. Click the Apply button.
Your settings are saved.
Recover local browser UI access after login
failures
When you use the Setup Wizard for the initial log-in process, you customize the local
device password and set up password recovery. If three local login failures occur, you
can try to recover access to the local browser UI and set a new password. This recovery
process is supported in the Chrome, Safari, Internet Explorer, and Firefox browsers.
To recover access and set a new local device password:
1.
Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2.
Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 34.
A login window displays.
User Manual95Maintain and Monitor
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
To Next Page
Loading...
