14.
Close and then reopen your browser, and enter http://www.routerlogin.net in the
address field.
The login window displays again.
If the login window does not display and your browser displays a security warning,
dismiss the warning. For more information, see Dismiss a browser security warning
on page 39.
If you experience connectivity problems, see You cannot log in to the AP [AP mode]
on page 145.
15. Enter your local device password.
The BASIC Home page displays.
16.
Find the new IP address of the AP in the local browser UI by doing the following:
a. Select ADVANCED > ADVANCED Home.
The ADVANCED Home page of the AP displays. The LAN Port pane shows the
IP address that is now assigned to the AP.
b.
Save the LAN IP address of the AP for later use.
You must use this IP address if you plan to connect to the same network as the
AP but not directly to the AP network. For example, use this IP address if you
connect over the LAN to the AP.
If you are directly connected to the AP over a WiFi connection or Ethernet
connection to one of the LAN ports, you still can use http://www.routerlogin.net.
17.
If you are using the AP in a country other than the U.S. or Canada (where the region
is set and you cannot change it), set the country or region where you are using the
AP by doing the following:
a. Select Advanced > Advanced Setup > Wireless Settings.
b. From the Region menu, select the country or region where you are using the AP.
Note: Make sure that the country is set to the location where the device is
operating. You are responsible for complying with the local, regional, and national
regulations for channels, power levels, and frequency ranges.
c. Click the Apply button.
Your settings are saved and the AP is configured for the new country or region.
Do not close the browser page. If you are connected over WiFi, your connection
might be terminated.
d.
If you want to continue to configure the AP, reconnect to the AP (if you were
connected over WiFi and your connection was terminated) and log back in to
the local browser UI by entering your local device password.
The BASIC Home page displays.
User Manual29Installation and Initial Login
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206