A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5. From the RIP Direction menu, select the RIP direction:
•
Both: The AP broadcasts its routing table periodically and incorporates information
that it receives. This is the default setting.
•
In Only: The AP incorporates the RIP information that it receives but does not
broadcast its routing table.
• Out Only: The AP broadcasts its routing table periodically but does not incorporate
the RIP information that it receives.
6. From the RIP Version menu, select the RIP version:
•
Disabled: The RIP version is disabled. This is the default setting.
•
RIP-1: This format is universally supported. It is adequate for most networks, unless
you are using an unusual network setup.
•
RIP-2B: This format carries more information than RIP-1, sends the routing data
in RIP-2 format, and uses subnet broadcasting.
•
RIP-2M: This format carries more information than RIP-1, sends the routing data
in RIP-2 format, and uses multicasting.
7. Click the Apply button.
Your settings are saved.
User Manual79Network Settings
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
To Next Page
Loading...
