Figure 2. Hardware interfaces
The bottom panel contains the following components:
•
DC power connector. If you do not use a Power over Ethernet plus (PoE+) switch
to provide power to the AP, connect the power adapter to the DC power connector.
•
Reset button. You can use the Reset button to restart the AP or to reset the AP to
its factory default settings. To restart the AP, press the Reset button for two seconds.
Pressing the Reset button for at least 11 seconds resets the AP to factory default
settings.
•
LAN/PoE+ port. Connect the LAN/PoE+ Gigabit Ethernet RJ-45 port to a PoE+
switch, or if you use a power adapter, to a non-PoE switch (that is, a common switch).
The LAN/PoE+ port supports Ethernet speeds up to 2.5 Gbps.
Note: If you do not use a power adapter, use a PoE+ (803.2.at) switch. If you use a
PoE (803.2.af) switch, the AP does not receive sufficient power for normal operation.
User Manual11Hardware Overview Model
WAX220
Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220
To Next Page
Loading...
