NETGEAR WAX220 - Mount the AP to a T-bar

Mount the AP to a T-bar
To mount the AP to a T-bar:
1.
If the T-bar lock is not yet attached to the metal bracket, slide the T-bar lock partially
into the metal bracket.
2. Attach the metal bracket to the T-bar.
3. Push the T-bar lock over the T-bar.
4. Use the lock screw to lock the metal bracket into place.
5.
Use the four short screws to attach the mounting plate to the T-bar.
User Manual131Mount the AP to a Wall or
Ceiling
Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220