6. Connect an Ethernet cable, or both an Ethernet cable and power adapter, to the AP
before mounting.
The AP is designed to be unobtrusive, so it sits flat on the ceiling surface when it is
mounted.
7. Hold the AP upside down at approximately a 45-degree angle, and attach it to the
mounting plate.
When viewed from the front, the latch points towards the lower left corner of the AP.
8. Twist the AP clockwise to lock it onto the mounting plate.
The opening at the bottom of the mounting plate latch locks onto the knob at the
bottom of the AP. In final position, the latch points directly towards the center bottom
edge of the AP.
User Manual132Mount the AP to a Wall or
Ceiling
Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220
To Next Page
Loading...
