NETGEAR WAX220 - Page 9

Figure 1. Top panel with LEDs
Table 1. LED descriptions
DescriptionLED Icon
Solid amber: The AP is starting. If the LED remains solid amber, the PoE power is not
at the required 802.3at (PoE+) level.
Power LED
Blinking amber: The firmware is being updated, or the AP cannot detect a DHCP server.
Solid green: The AP is powered on and ready.
Off: No power is supplied to the AP.
Solid green: The LAN/PoE+ port detects a 2.5 Gbps link with a powered-on device.LAN LED
Blinking green: The LAN/PoE+ port is processing traffic at 2.5 Gbps speed.
Solid amber: The LAN/PoE+ port detects a 1 Gbps or 100 Mbps link with a powered-on
device.
Blinking amber: The LAN/PoE+ port is processing traffic at 1 Gbps or 100 Mbps speed.
Off: Either no powered-on Ethernet device is connected to the LAN/PoE+ port, or, if a
powered-on Ethernet device is connected, no Ethernet link is detected.
User Manual9Hardware Overview Model
WAX220
Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220