NETGEAR WAX220 - Page 97

Table 3. Memory Information section (Continued)
DescriptionSetting
The total memory in KB and the cached memory in KB and percentage.Cached
The total memory in KB and the buffered memory in KB and percentage.Buffered
Table 4. LAN Information - IPv4 section
DescriptionSetting
The IPv4 address that is assigned to the LAN/PoE+ port of the AP. This is the IPv4
address over which you can reach the device UI. For more information, see Set a
static IPv4 address on page 29.
IP Address
The subnet mask that is associated with the IPv4 address.Subnet Mask
The IPv4 address of the gateway.Gateway
The IPv4 address of the primary DNS server.Primary DNS
The IPv4 address of the secondary DNS server, if any.Secondary DNS
Shows whether the DHCP client of the AP is enabled (which it is by default). For more
information, see Reenable the DHCP client of the AP on page 30.
DHCP Client
Table 5. Wireless LAN Information - 2.4GHz section
DescriptionSetting
The WiFi mode, which is fixed at 802.11 ax/n/g/b.Wireless Mode
The WiFi channel bandwidth. For for information, see Manage the channel high
throughput mode on page 67.
Channel Bandwidth
The WiFi channel. For for information, see Manage the WiFi channels on page 68.Channel
User Manual97Monitor the AP and its Network
Connections
Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220