NETGEAR WAX638E - Page 254

Table 3. Factory default settings (Continued)
Default SettingFeature
Enabled so that the access point receives an IP address from a DHCP server or router
in the network.
DHCP client
EnabledNTP client
DisabledSpanning Tree Protocol
DisabledNetwork integrity check
DisabledIGMP snooping
Untagged VLAN with VLAN ID 1802.1Q VLAN
VLAN ID 1Management VLAN
DisabledSyslog
EnabledEthernet LLDP
EnabledUPnP
DisabledLink aggregation
DisabledMulticast DNS gateway
All enabledLEDs
DisabledEnergy Efficiency Mode
WLAN settings for an individual WiFi network (SSID or VAP)
EnabledBroadcast SSID
1VLAN ID (for WiFi clients)
WPA3/WAP2 Personal
WPA3 uses SAE encryption; WPA2 uses AES encryption
Network authentication
Disabled802.11w (PMF)
DisabledMulti PSK
Always onBroadcast schedule
All enabledRadio bands
Disabled
Automatic band steering includes automatic 802.11k RRM and automatic 802.11v
WiFi network management.
Band steering
DisabledWiFi client isolation
DisabledURL tracking
User Manual254Factory Default Settings and
Technical Specifications
Insight Managed WiFi 6E AXE7800 Tri-band Multi-Gig Access Point Model WAX638E