NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111v3 User Manual
1-5
v1.0, March 2008
After you have connected the wireless adapter, the following screen displays:
To use the Smart Wizard to configure the wireless adapter:
1. Click Next to accept the Smart Wizard.
You will be prompted to let the wizard help you connect to a network (recommended).
2. Click Next to accept.
3. Depending on whether or not a wireless access point or router in the network supports a Wi-Fi
Protected System (WPS), there are two possibilities:
• If a wireless access point or router in the network supports WPS, a WPS screen displays.
See
“Using WPS to Connect to a Wireless Network” on page 2-5.
Figure 1-3
Note: The NETGEAR 54 Mbps Wireless USB2.0 Adapter WG111v3 only
supports WPS on Windows 2000, XP, XP x64 and Vista (32/64 bits).
To Next Page
Loading...
