NETGEAR WG111v3 - 54 Mbps Wireless USB 2.0 Adapter

NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111v3 User Manual
2-10
v1.0, March 2008
c. In the Network Name (SSID) field, select a network or enter the SSID.
3. Save your settings in a profile.
a. Click Save Profile.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the wizard, or Cancel to return to the previous settings.
4. Check to make sure that you can connect to your network and to the Internet. For example, use
your browser to connect to the Internet, or check for file and printer access on your network.
If you cannot connect, check the Status bar in the Smart Wizard. See “Smart Wizard Status
Bar” on page 1-8. For problems with accessing network resources, the Windows Client and
File and Print Sharing software might not be installed and configured properly on your
computers. See the link to
“Internet Networking and TCP/IP Addressing” on page B-1.
Figure 2-7
Note: You will not get a wireless network connection unless the network SSID
matches exactly the SSID used by the access point.