NETGEAR WGPS606

Reference Manual for the NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch
2-6 Introduction
202-10083-01
Power Socket
This socket connects to the WGPS606 power adapter.
Reset and Restore to Factory Defaults Button
The reset and restore to defaults button located between the Ethernet RJ-45 connector and the
power socket resets the WGPS606 when pushed once or restores to the factory default settings
when pushed and held for 10 seconds.
RJ-45 Ethernet Port
Use the WGPS606 Ethernet RJ-45 port to connect to an Ethernet LAN through a device such as
a hub, switch, or router.
Antenna
The WGPS606 includes antenna. Be sure the antenna is positioned vertically for best
side-to-side coverage and horizontally for best up-and-down coverage.
Switch Status Lights Ethernet LAN Link Activity Indicators
Off/
Green On
Indicates no Ethernet link detected.
100 Mbps Fast Ethernet link detected, no activity.
Green Blink Indicates data traffic on the 100Mbps Ethernet LAN.
Yellow 0n 10 Mbps Ethernet link detected, no activity.
Yellow Blink Indicates data traffic on the 10Mbps Ethernet LAN.
ITEM DESCRIPTION