NETGEAR WN121T User Manual

NETGEAR Next 300 Mbps Wireless USB 2.0 Adapter WN121T User Manual
1-3
v2.0, February 2007
Your Wireless USB 2.0 Adapter factory default basic settings are:
• Network Name Service Set Identification (SSID): Any (First available network)
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WEP, WPA2-PSK, or WPA-PSK encryption: Disabled
Installation
The instructions in this chapter are for an Access Point (Infrastructure) installation. Wireless
security, advanced settings, and Computer-to-Computer (Ad Hoc) instructions are covered in
Chapter 2, “Network Connections and Wireless Security”.
To install the Wireless USB 2.0 Adapter:
1. First, install the WN121T software.
Insert the NETGEAR CD. If the CD main page does not appear, double click Autorun.exe on
the CD.
a. Click Install the Software. The Check for Updates window opens.
b. If you are connected to the Internet, click Check for Updates. If not, you can choose to
install from the CD.
Note: In order for the Wireless USB 2.0 Adapter to communicate with a wireless
access point or wireless adapter, all devices must be set up to use the same
wireless network name (SSID).
Figure 1-1

NETGEAR WN121T Specifications

Wireless Speeds

802.11b speeds	1, 2, 5.5, 11 Mbps
802.11g speeds	6, 9, 12, 18, 24, 36, 48, 54 Mbps
802.11n draft speeds	6, 6.5, 13, 13.5, 19.5, 26, 27, 39, 40.5, 53, 54, 58.5, 65, 78, 81, 104, 108, 117, 121.5, 130, 135, 162, 216, 243, 270, 300 Mbps

Weight and Dimensions

dimensions	103.99 x 91.98 x 16 mm
weight	2.59 oz (73.6 g)